Textile Testing: Purpose, Sampling and Common Fabric Tests
Original introductory revision notes explaining why textiles are tested, why sampling matters and what common fabric tests measure. Refer to NPTEL Evaluation of Textile Materials for deeper study.
WHY TEXTILE TESTING IS DONE
Textile testing measures the properties of fibres, yarns and fabrics. It helps check quality, compare materials, control manufacturing processes and decide whether a material is suitable for its intended end use.
SAMPLING – IMPORTANT IDEA
A test specimen should represent the material being evaluated. Samples are selected from the lot using a defined sampling plan. Conditioning and test atmosphere can affect results, so the applicable test method and standard must be followed. Do not compare results obtained using different methods or conditions as if they were identical.
COMMON FABRIC TESTS – WHAT THEY MEASURE
• Fabric mass per unit area (GSM): Mass of fabric per square metre, usually expressed in g/m².
• Thickness: Distance between the two fabric surfaces under the specified pressure and test conditions; commonly reported in mm.
• Tensile strength: Force required to break a fabric strip under a specified tensile test method; report units and method used.
• Tear strength: Force or work associated with propagating a tear, depending on the test method.
• Abrasion resistance: Resistance to surface wear caused by rubbing.
• Pilling resistance: Tendency of a fabric surface to form pills under a specified rubbing/wearing action; results are often assessed using a rating scale defined by the method.
• Air permeability: Rate of air passing through a fabric under a specified pressure difference; units depend on the test standard and instrument.
• Dimensional stability: Change in fabric dimensions after a specified treatment, often expressed as percentage change.
• Crease recovery: Ability of a fabric to recover after creasing, measured using the specified crease-recovery method.
• Wicking: Movement of liquid along or through a textile material by capillary action; the method may report height or distance over a stated time.
GENERAL TESTING WORKFLOW
1. Identify the property and the relevant test standard.
2. Select representative specimens and prepare them as required.
3. Condition specimens when the method requires it.
4. Set and verify the instrument according to its instructions and the standard.
5. Conduct the required number of tests.
6. Record individual readings, calculate the result as specified and report units, method and test conditions.
IMPORTANT CAUTION
There is no single universal unit or procedure for every test name. Always follow the particular instrument manual and applicable standard used in your laboratory or examination.
Offline study
Save this published learning material on this device. It will be available offline until you remove it or clear browser storage.
Sign in to bookmark this resource and track your learning progress.
Course
Diploma / B.Tech
Branch
Textile Technology
Semester
General revision
Subject
Textile Testing and Quality Control
Source
EduIndia original notes; NPTEL Evaluation of Textile Materials