Strength of Materials: Stress, Strain and Elastic Constants (Revision Notes)
One-page revision of axial stress and strain, Hooke's law, elastic constants and factor of safety.
STRESS AND STRAIN
- Normal stress: sigma = P / A (force perpendicular to the area; unit Pa = N/m2).
- Normal strain: epsilon = change in length / original length (dimensionless).
- Average shear stress: tau = V / A. Shear strain gamma is the change in angle, in radians.
HOOKE'S LAW (valid up to the proportional limit)
- sigma = E x epsilon, where E is Young's modulus.
- tau = G x gamma, where G is the shear (rigidity) modulus.
- Axial deformation of a uniform bar: delta = P L / (A E).
POISSON'S RATIO
- nu = - (lateral strain) / (axial strain). It is positive for common materials.
RELATIONS BETWEEN ELASTIC CONSTANTS (isotropic, linear elastic material)
- E = 2G (1 + nu)
- E = 3K (1 - 2 nu), where K is the bulk modulus.
THERMAL EFFECTS
- Free thermal strain: epsilon = alpha x dT.
- If expansion is fully prevented, thermal stress = E x alpha x dT.
STRESS-STRAIN CURVE (ductile metal) - key points in order
Proportional limit -> elastic limit -> yield point -> strain hardening -> ultimate strength -> fracture.
Brittle materials fracture with little plastic deformation.
FACTOR OF SAFETY
- FoS = failure stress (yield or ultimate, as specified) / allowable stress.
EXAM TIPS
- Always state units and whether stress is tensile or compressive.
- Hooke's law applies only in the linear elastic range.
- Check which stress (yield or ultimate) your question uses for the factor of safety.
Offline study
Save this published learning material on this device. It will be available offline until you remove it or clear browser storage.
Sign in to bookmark this resource and track your learning progress.
Course
UG / Diploma
Branch
Mechanical Engineering
Semester
General revision
Subject
Strength of Materials
Source
EduIndia original notes; NPTEL Strength of Materials (IIT Madras)